Accueil
thermistance ender 3 v2
hotend - K-Thermistor vs Ender 3 Stock Thermistor: Problem with

hotend - K-Thermistor vs Ender 3 Stock Thermistor: Problem with

4.6 (345) · € 21.50 · En Stock

I have changed my hotend on my Ender 3 v2 with Dragonfly BMS. In effect, because I wanted to reach higher temperatures, I also changed the thermistor with one that is 3mm wide and does not have the

Ender 3 v2 all metal hotend upgrade - NotEnoughTech

Hotbed thermistor problem AGAIN : r/Sovol

Qidi Tech Hotend Thermistor - 3DJake International

Wire Length: 51.1inch /1.3m. The package includes 5 3D printer thermistors. 2-pin XH2.54 female connector. Note Before Buying: Our Ender 3 thermistor

5PCS Creality 3D Printer NTC Thermistor 100K, NTC 3950 100K ohm Thermistor Temp Sensor for Creality Ender 3/Ender 3 Pro/Ender 3 Neo/Ender 3

Buy Ender 3/Ender 3 Pro High Temperature Full Hotend Kit

Upgrade HT-NTC100K 3950 Thermistor: Pack of 3Pcs. Note: Temperature measurement head cylinder diameter is 3mm, length 15mm, The connector is 2pin

FYSETC 3D Printer Ender 3 V2 Neo Hotend Part HT-NTC100K 3950 Thermistor Cartridge Cable 1M/39.3inch XH2.54 2Pin Compatible with Ender 3 Ender 5 Pro

Ender 3 Pro Thermistor issue? : r/3Dprinting

Official Creality heating tube and thermistor replacement. 【Easy to Install】The heating tube has XH2.54 interface, and the resistance has XH1.25

Creality Ender 3 S1 / Plus Heating Tube Heater Cartridge 24V 40W and NTC 100kΩ 3950K Thermistor Replacement for 260℃ Spirite Exruder Standard Hotend

Jams and clogs with PLA after microswiss hotend (Mellow version) installation on Ender 3. Retraction 1.5mm 45mm/s. Used stock thermistor/heater and same nozzle. Stock hotend I could print benchy perfectly. What could

I'm currently in the middle of installing my Dragonfly hot end and I wanted some advice on a what thermistor and heat cylinder to get as an upgrade (for higher temperatures) I