4.5 (788) · ⏠21.99 · En Stock
This is probably my 20th design of the case, I
This is probably my 20th design of the case, I've been making these for some time, constantly improving the design. The whole idea is to wear GoPro as if it was a camera, on your neck. This design also covers the front display on 9 to be discrete.
This design has a slanted back to sit on your chest so it very slightly point up from your chest as to have the correct framing.
After printing: The GoPro sits in the case without the door so the USB is accessible all the time. You need to glue a 14mm width of craft foam (wal-mart etc) on the left side so it will be keeping the battery pushed in. (See images)
The case has 6 vertical holes going from top to bottom through the whole case - these are to glue in a filament or a wire to firmly secure the print in the less durable vertical direction. It depends on your tolerance if you can push a filament in or you need to expand the hole a little with drill bit. You can also choose copper wire etc. Then you can snip the ends (and in the hole where the strap goes in).
You can also glue a thin piece of fabric where the front display goes to keep it from scratches.
Tip for finish: I used plasti dip spray and it gives it a very pro look. The coating usually last a year - spray a very thin layer as not to start peeling.
I had been using these cases for travel and they are fantastic making GoPro nearly invisible camera on your neck. With the stabilization boost, you can turn it on and then just walk for smooth like results.
STL file GoPro Hero 9 Case STL đ±ă»3D printing model to downloadă»Cults
STL file GoPro Hero 12/11/10/9 Black Pocket Insert đ·ă»3D printer design to downloadă»Cults
Gopro 9 best 3D printer modelsă»42 designs to downloadă»Cults
This is a protective cover for the Naked GoPro 9/10/11 from GEPRC., With the pressure settings used, this case weighs only 14 grams and the GoPro is
GoPro Hero 9/10/11 GEPRC Naked Case / Protective Cover
For the original GoPro Hero 12 bag that is included with the delivery. For original equipment. ;), A nicely sorted insert for the GoPro Hero 12
GoPro Hero 12/11/10/9 Black Pocket Insert
STL file Gopro Hero 9 Black, Gopro Hero 10 Black, Frame, PRINT-IN-PLACE đŒïžă»3D printer design to downloadă»Cults
hero 7 black 3D Models to Print - yeggi
STL file Ultimate GoPro Hero 9 camera neck strap case đ·ă»3D printer model to downloadă»Cults
STL file Ultimate GoPro Hero 9 camera neck strap case đ·ă»3D printer model to downloadă»Cults
Organization case for GoPro Hero 9. This is printable on 3d printers under 220mm X 220mm if you remove skirt settings. I printed this on my ender3 v2.
GoPro Hero 9 Case STL
Gopro Hero 9 / 10 / 11 Dummy file with and without Gopro Feets, as .step and .stl file
Gopro Hero 9 / 10 / 11 Dummy File