How to use JTAG built-in debugger of the ESP32-S3 in PLATFORMIO
4.9 (138) · € 35.50 · En Stock
How to use JTAG built-in debugger of the ESP32-S3 in PLATFORMIO Most of the internet examples are showing using the ESP32-S3 built-in debugger in ESP-IDF, but I´m going showing how to do it in VSC PLATFORMIO. Uses the ESP32-S3’s own USB port to upload the firmware and debug the software on the PLATFORMIO. Allows you to use the standard serial port on the ESP card/recorder for normal serial communication at the same time. The video below is very complete and explains how to configure the ESP32
Getting started with the Sunton ESP32-S3 7 inch display, LovyanGFX and LVGL
ESP32 S3 Build-in Debugging using JTAG interface.
PlatformIO JTAG Debug Adventure on ESP32 – New Screwdriver
How to debug an ESP32 with an Arduino project and GDB?
i am having trouble uploading code to esp32-s3 via platformio : r/esp32
Debugging - esp32-s3-devkitc-1 and ESP-PROG - Advanced Solutions - PlatformIO Community
How to do ESP32 PlatformIO Debugging - Arduino Blink Code in 8 Simple Steps
ESP32-S3 Built-in JTAG not recognized under Windows - Debugging - PlatformIO Community
Getting Started with Arduino Nano ESP32 Wi-Fi & IoT Development Board - CIRCUITSTATE Electronics
VS Arduino - ESP-PROG debugger xtensa_write_memory indicates target still busy
