5 (474) · € 24.50 · En Stock
Need advice reducing the stringing on PLA-LW (ColorFabb). I've been following the tutorial and can do perimeters just fine and clean, but having a lot
Help printing ttyt3D silk filament on MK3S+ – How do I print this
Still having retraction issues – General discussion, announcements
Severe stringing issues – Assembly and first prints
Stringing issue – How do I print this? (Printing help) – Prusa3D Forum
Can't stop the stringing! – Assembly and first prints
Slicer settings for LW-PLA RC Aircraft – How do I print this
Stringing, Oozing, Dragging, Levelling issues – Hardware, firmware
MK4 - stringing problem : r/prusa3d
How to achieve a fully filled in first layer – How do I print this
Stringing Issues - Page 5 – Assembly and first prints
3D printing large surfboard fins - General Discussion - SWAYLOCKS
MK4 PLA Stringing - Página 2 – Assembly and first prints
Issue with PLA – How do I print this? (Printing help) – Prusa3D Forum